The unit is shipped with the shelf
supports in approximate locations.
You need to install shelves
and move to locations desired.
3.
Install
shelves -- Lay the unit on its back with top away from you. One end of the shelf
has a black dot on it. Insert the shelves into open lips of the clip sets
making sure that the end with the black dot is to the right side of the
unit and is facing the bottom of the unit.
Using a Phillips head screwdriver reverse the screw to release pressure
on the spring so that the clip assembly grips the shelf. The screw has to
be backed off enough to be able to move the shelf to desired location.
4.
Move shelves to desired location
--
At this point the clip assembly, with the shelves installed, may be moved
to final vertical locations.
Move both ends of the shelf at the same time. Push on the clip assembly —
not the shelf SEE PICTURE ABOVE
Tighten screws on one side of cabinet and adjust shelves horizontally
before tightening screws on opposite side.
CAUTION:
Do not
over tighten — Do not use
power screwdriver! |
